Colorado Trail
New member
- Joined
- Feb 21, 2022
- Messages
- 13
The internal bar weights on these bikes are weirdly large and a pain to remove, you might need to pull them out to install different bar weights or install handguards, here is a quick way to do it that doesn't require any special tools, although it does go more easily with a small impact driver.
Step 1 - remove bar weight
Step 2 - insert 18mm socket under grip
Step 3 - place washer over bar weight screw
Step 4 - thread screw through the center of the socket
Step 5 - tighten screw until the internal weight bottoms out on the socket
Step 6 - remove screw, washer, and socket
Step 7 - thread screw back into weight and start pulling, the rubber grommets on the weights will fight you a bit, but all in all, it's not terrible
Step 1 - remove bar weight
Step 2 - insert 18mm socket under grip
Step 3 - place washer over bar weight screw
Step 4 - thread screw through the center of the socket
Step 5 - tighten screw until the internal weight bottoms out on the socket
Step 6 - remove screw, washer, and socket
Step 7 - thread screw back into weight and start pulling, the rubber grommets on the weights will fight you a bit, but all in all, it's not terrible
Attachments
Last edited: